If you want to pair a BMW Navigator V to a SENA SMH10 (or SMH5) Bluetooth headset, there're a few things you should know.


First things first. Always use the latest firmwire on your SENA Bluetooth headset. You can download it here after product registration.

Be sure to set the firmware settings according to this screenshot:

0099-001

By default, the VOX Intercom option is disabled. Be sure to enable it! Press the SAVE button to save the settings in the headset.

After upgrading the firmware you'll have to reset the headset to it's default settings. This also cleares all existing pairings.

  1. Power on the headset by pushing the red Phone Button and de Jog Dial simultaneously, the headset will respond with "Welcome".
  2. Push the Phone Button for about 10 seconds, the headset will respond with "Factory Reset".
  3. Push the Jog Dial once, the headset wil respond with "Headset reset" followed by "Goodbey".

Now you are ready to pair the headset to the GPS unit.


Pairing a BMW Navigator V to a SENA Bluetooth headset:

  1. Power on the headset by pushing the Phone Button and de Jog Dial simultaneously.

  2. Power on the GPS device by pushing the Power Button on the backside.
  3. Press Settings --> Bluetooth.
  4. Set both the Bluetooth option and the Visible option to Enabled.
  5. If they exist, clear all registered bluetooth headset pairings.
  6. Press Scan for Devices. Press OK.

  7. Active the paining mode on the headset bij pushing the Phone Button for about 5 seconds, the headset will respond with "Phone Pairing".
  8. Wait until both devices found each other and confirm the messages appearing on the GPS device.

Now both devices should be paired correctly using the A2DP protocol . You should see:

0099-002-uk


Connection diagram:

0099-003

{jcomments on}


Kalender

November 2021
M D W D V Z Z
1 2 3 4 5 6 7
8 9 10 11 12 13 14
15 16 17 18 19 20 21
22 23 24 25 26 27 28
29 30

Evenementen

Geen evenementen

Supporter of Bastien MACKELS

Bastien MACKELS
Superbike IDM
Moto GP